|
Quantity
|
Total
|
||
|
|
|||
|
|
|||
🫖 Late Qing Shui Ping, 19th century
🔎 This archaic shape of shuiping has been known since the late Ming Dynasty, and it became widespread during the reign of Emperor Qianlong (1735 - 1796). The first teapots had a grain of ~30 Mesh, which was equal to a clay fraction diameter of no more than 0.5 mm. This teapot does not belong to the Qianlong period, but is its late Qing version. The dating of its manufacture can be confidently called the 19th century, if we take into account that the late Qing period is 1820 - 1912. Thus the teapot is 150-200 years old.
🧱 Hong Ni clay (red). Ceramics with a large grain, with a pattern of microscopic cracks that formed during firing.
⛏️ Not only clay is interesting, but also its extraction and processing, since all processes were carried out exclusively by hand. First, laborers extracted the rock with picks and carried it in baskets to the assembly site, after which the master manually sorted the material needed for making the teapot. After selection, the sorted clay was piled up for weathering for a certain time, up to a whole season. Then it was crushed, sifted and water was added, after which the clay was kneaded with feet. The next stage was "clay training", that is, repeatedly beating it with a wooden hammer and folding it for aging for up to 6 months. Then the second training and making the teapot. This teapot is fired in a dragon tunnel kiln on wood or coal.
🏺 The teapot is completely handmade. Pay attention to the seam inside the body near the handle - this is a trace of gluing the clay during manufacture. Take a sheet of paper and roll it into a cylinder, this is how this teapot is assembled. Then the bottom was glued, longitudinal traces of rolling with a stick are also visible on the bottom, after which the rim of the neck was glued. The manufacture of the lid looks especially interesting, since it was also formed by hand, after which the rim was glued, which was then pressed with fingers, the traces of which remained on the rim. That is, a teapot with traces of the master's hands.
💎 Although the teapot is rich in its history and has a respectable age, it is intended for use, not storage on a shelf. This is another proof that you will never get from modern teapots.
✨ The body of the teapot is completely intact, even the entire spout (except for the chipping at the tip) and the handle, which is already a miracle, but the lid was damaged. The button fell off, but was put back together using two pins and the urusha gluing technique. The chip on the edge of the lid was first formed with a metal frame, then completed with a frame of kokuso-urushi and then sabi, several layers of varnish and bronze powder. I use only natural urushi varnish, no epoxies. The varnish is fully polymerized and the kettle is ready for use.
🧂 Each single-hole kettle is equipped with a food-grade stainless steel filter-nest.